• Availability: > 80
  • €15.79 / szt.

High quality fuga to cement tiles.

Mortar based on nanotechnology intended to bind tiles together.

Fuga's features
- usage to 1-20mm weld.
- high durability
- waterproof
- immune to rubbing
- 1 package of 2 kg is enough for 5,5 m2

Usage conditions: USing in +5°C do +25°C, temperatures re;ate.


Ground preparation: After putting tiles. make sure that ground is dry than proceed with Fuga. Make sure joints are clean and flat

Preparations: Dry mixture put into conatiner with water than mix then tugether untill they blend completly. Put it away for 5 minuts then mix them again. If there is a need add a little of extra water. Be carefull, too much water may cause problems during putting proccess.

Usage: Ready mortar put into joint by using spatula. Remove surplus by using wet sponge. To final clean use soft cloth. Be carefull not to rub dust in. In case of solourfull fuga be carefull not to dye tiles.

Additional notes To get the monocolour surface please notice that the surface is protected during drying phaes. Water and humid might change the fuga's colour. Final colour will be seen when the mortar will be dry. It is recomended to clean the surface during  first 3-4 week period only by water.

Fuga's features
- usage to 1-20mm weld.
- high durability
- waterproof
- immune to rubbing
- 1 package of 2 kg is enough for 3,5 m2